Holybro PM02 V3 Power Module Pixhawk 4 Power Module
Holybro PM02 Power Module is a simple way of providing your autopilot flight controller with clean power from a LiPo battery as well as current consumption and battery voltage measurements, all through a 6-pos cable. The on-board switching regulator outputs 5.2V and a maximum of 3A from up to a 12S LiPo battery. The Power Module comes completely assembled with XT60 connectors, and wrapped in shrink tubing for protection.
The Power Module is designed to power autopilot flight controller, a RC receiver and APM accessories (GPS, radio). It is not designed to power servos. Use your aircraft's own ESC/BEC for that.
The GH terminal is also compatible with Pix32,Pixhawk4,Pixhawk4 mini, Pix32v5 and Durandal.
UBEC input voltage : 7~51v (2~12s LiPo)
Max current sensing: 120A
Supports 12S battery
Voltage and current measurement configured for 3.3V ADC
Switching regulator outputs 5.2V and 3A max
1x Power Module with XT60 Connectors Board
1x Electrolytic capacito: 220uF 63V (installed)
1x Molex 6 Position Connector 15 cm
1x GH 6 Position Connector 15 cm