Jumper T18 Carbon Fiber JP5in1 Multi-protocol RF Module OpenTX Radio With Hall Gimbals
Note: Jumper T18 is for Pre-order now!! It will be available on about 5.20. Worldwide shipping!!!
The Jumper T18 brings the best features of the T16 series and upgraded the JP4IN1 module into JP5IN1 (2.4G JP4IN1 and 915mhz / 868mhz) . Jumper T18 radio also added adjustable LED back lights. What's more, there are two power buttons, with this, you can turn off the radio quickly without waiting for a long time. Jumper T18 also has the 800*480 HD IPS touch screen interface reserved - expected to be supported by openTX2.4 and above.
Jumper is focusing on providing hardware compatible with various open source projects. They are always working on bring out better products. If you are looking for a radio can control long range without extra module attached to the radio---Jumper T 18 multi-protocol Opentx radio is your best choice.
What's the difference between the T18 and T16 Pro?
1. Jumper T18 has JP5IN1 multi - protocol module, with 2.4G JP4IN1 and 915mhz / 868mhz at same time.
With it, you can control your mini quads and air-planes at same time without any extra module attached.
2. Jumper T18 has new added adjustable LED back lights.
3. Two power buttons on T18 radio can make sure you can turn off the radio quickly enough.
4. Adjustable neck strap hook balancer can relieve your neck weight
--JP5-in-1 Multi-protocol module included R9, DSM2/X, FrSKY, SFHSS, FlySky, FlySky AFHDS2A, Hubsan and more
--Zipper Case Included
--Adjustable LED Backlights
--Vibration reminder function
--USB-C online firmware upgrade
--JR/FrSKY compatible module bay on rear side.
--JP5IN1 module - 2.4G JP4IN1 and 915mhz / 868mhz
--6-Flight Mode Buttons (for APM and Pixhawk flight controllers)
--Support telemetry (depending on the receiver)
--Up to 16 channels of output (can be extended into 32ch, depending on the receiver)
Item Brand: Jumper
Item Model: Jumper T18
Faceplate: Carbon Fiber
Gimbal Type: Hall Sensor
Weight: 888g (without battery)
Working voltage: DC7-8.4V (NO CRSF)
Channels: up to 32 channels (depending on the receiver)
Display: IPS480*272 (800 * 480 HD IPS touch screen interface reserved - expected to be supported by openTX2.4 and above)
Simulator mode: 3.5mm standard ppm output or USB HID
- 1 x Jumper T18 OpenTX radio
- 1 x Zipper case
- 1 x USB-C cable
- 1 x Jumper orange neck strap