Happymodel Larva-X HD  125mm 2-3S 2in1 Racing Drone Whoop Toothpick BNF with Caddx Turtle Camera
Happymodel Larva-X HD  125mm 2-3S 2in1 Racing Drone Whoop Toothpick BNF with Caddx Turtle Camera

Happymodel Larva-X HD 125mm 2-3S 2in1 Racing Drone Whoop Toothpick BNF with Caddx Turtle Camera

Item# CA0276
USD $164.99
frsky D8(CA0276)flysky(CA0277)dsmx/dsm2(CA0278)(+$10)frsky xm+(CA0279)(+$10)frsky r-xsr(CA0280)(+$15)TBS crsf(CA0281)(+$15)
[out of stock]

Note: The 3S 450mah 30C Battery is not included due to the shipping problem, you need to purchase it separately.You can order QA0031 from our website that is available in US warehouse.


1.Toothpick HD and Whoop HD 2 in 1 combo (Default Comes in Toothpick HD style)
2.Toothpick style compatible both 2.5 inch or 3 inch propellers
3.New design EX1203 High efficiency brushless motors
4.Caddx baby Turtle provide 1080P 60FPS DVR video
5.Full range receiver options
6.Smooth and powerful
7.Compatible both for 2s-3s Lipo/LIHV

Package Included:
1x Larva X HD FPV Drone
1x 5.8g Micro UXII Antenna
1x Propeller Disassemble Tool

Brand Name: Happymodel
Model: Larva X HD
Item Name: Larva X HD 125mm F4 2-3S Toothpick HD Whoop HD 2in1 FPV Racer
Wheelbase: 125mm
Size: 105x105x35mm (without propellers)
Weight: Toothpick style ductless 63g (without battery)
Whoop style ducted 79g (without battery)


EX1203 6200KV Motor Configuration: 9N12P
Stator Diamter: 12mm
Stator Length:3mm
Shaft Diameter: Φ1.5mm
Motor Dimension(Dia.*Len): Φ15x5mm
Weight: 4.7g
No.of Cells: 2-3S Lipo
Crazybee F4FR PRO Flight Controller
Frsky SPI RX version: CRAZYBEE F4FR PRO V3.0 Firmware target: CrazybeeF4FR
Flysky SPI RX version:  CRAZYBEE F4FS PRO V3.0 Firmware target: CrazybeeF4FS
External RX version: CRAZYBEE F4 PRO V3.0 Firmware target: CrazybeeF4DX
MCU: STM32F411CEU6 (100MHZ, 512K FLASH)
Sensor: MPU-6000(SPI connection)
Board Size: 28.5x 28.5mm
Power supply: 2-4S battery input (DC 7-17V)
Built-in 10A(each) Blheli_S 4in1 ESC Dshot600 ready
Could add external receiver on the FC board
Built-in Betaflight OSD(SPI Control)
Built-in Current meter Max 70A
Current meter scale set to 470
Built-in 5V 1A BEC
Built-in voltage detection
Onboard 12A 4in1 ESC
MCU upgraded to EFM8BB21
Power supply: 2-4S LiPo/LiPo HV (7v/17v)
Current: 10A continuous peak 12A (5 seconds)
Support BLHeliSuite programmable
Factory firmware: F_H_40_REV16_7.HEX
Default protocol: DSHOT600
Built-in Frsky SPI D8 Receiver Version SPI BUS receiver Frsky D8 compatible
Compatible Non EU transmitter D8 model
Channels: 8ch
Failsafe support
No ground interference ( Transmitter and receiver 1 m from the ground): 100m~200m
- Support add extral external receiver if you need
Built-in Flysky SPI Receiver Version SPI BUS receiver
Protocol: AFHDS and AFHDS-2A Switchable
Channels: 8ch(AFHDS) or 14ch(AFHDS-2A)
No ground interference ( Transmitter and receiver 1 m from the ground): 100~200m
Failsafe support
- Support add extral external receiver if you need
External DSMX/DSM2 Receiver Version
Resolution: 1024/2048
Operating voltage: 3.3V
Working current: 60MA
Size: 18mm*13mm*5mm
Antenna length: 30mm
Protocol: DSM2/DSMX
External Frsky XM+ Receiver Version
Number of Channels: Up to 16CH from SBUS (1-15ch for PWM,16ch RSSI for FC)
Operating Voltage Range: 3.7~10V
Operating Range: Full range
With RSSI output on board: Analog 0~3.3V
Antenna: 10cm
Firmware Upgradeable
Compatibility: FrSky D16 mode
External Frsky RXSR Receiver Version
Weight: 1.5g
Number of channels: 16CH (1-16CH from SBUS channel, 1~8CH from CPPM channel)
Operating Voltage Range: 3.5V~10V
Operating Current:70mA@5V
Firmware Upgradable
Compatibility: FrSky X Series modules and radios in D16 mode 
Could support Frsky New ACCST Protocol ( Upgrade firmware)
External TBS CRSF Nano Receiver Version Original TBS CROSSFIRE Receiver , CRSF Protocol , Official TBS transmitter compatible
5.8G 40CH 25-200mW VTX
Output power: 25~200mw switchable
Frequency: 40CH
Input voltage: 3.3V 5.5V
Current consumption: 300mA(type)
Antenna: Micro UXII Antenna
Frequency: 5.8GHz 5bands 40 channels
With Race band 
Smartaudio ready
Weight: 3g
Caddx Baby Turtle Camera
TV system: NTSC/PAL changeable
Video Resolution: 1080P@60fps / 1080P@30fps / 720@60fps
Power Input: DC 4.5-20V
Mini Illumination: 0.01lux
Image Resolution: 2 Megapixels
Working Current: 380mA@5V/160mA@12V (low consumption)
OSD Menu: Yes (Support Voltage Display)
Video Files: MP4
Audio: Support
Electronic Shutter : PAL : 1/50-100,000 NTSC : 1/60-100,100
S/N Ratio: >60dB (AGC OFF)
Video Output: CVBS
3S 11.4V 450mAh 75C Lipo Battery(not include)
Continuous Discharge Rate: 75C
Size: 66mmx21mmx18mm
Weight: 42g
Connector: XT30